4 Knowledge Base

 

 TelecomTrainning.net > Knowledge Base
 Viewing KB Article
Good Morning, - Please register or - log-in to your account.
Search
Search   Saved Questions   Ask a question
Keywords 
 
Available categories
LTE
100 of Questions in LTE
CCNA Certification
CCNA Sample Q & A (1000 + Q &A)
(Network +) Certification
(Network +) Sample Q & A (1000 + Q &A)
Networking
General/Interview Q& A on Networking
Home Networking
General/Interview Q& A on Networking
VOIP, SIP & Asterisk
Q & A on VOIP,Ethereal, SIP & Asterisk
Telecom Test Equipments
Q & A on Telecom Test Equipment
PSTN / Wireline
General / Interview Q & A on PSTN / Wireline
LTE, Wireless, 3G ,Diameter and HSS
General/Interview Q & A on LTE, Wireless, 3G ,Diameter and HSS
Telecom General
Any Q & A in Telecom in General

Top Questions
Friends, Describe Secure storage and distribution of A-Keys?
what is the difference between E1 signal & Ethernet signal ?
How do I monitor SS7 Traffic in spectra2?
Can you tell me about PBGT?
Explain me the difference between a repeater, bridge and router? Relate this to the OSI model.
What is the difference between BRI & PRI ?
Guys what is the purpose of Umbrella Cell Approach in GSM ?
how can we explain media gateway in MSc?
What is the difference between Electrical-tilt and Mechanical-tilt of an antenna?
What is GGSN?
What is BSC?
What is demarc point?
Can any one explain me how sms flow will work using ss7 network ?( from physical layer to application layer)
why cellphone towers are painted in red and white?
Explain SLTA and SLTM messages in MTP3?
Hi guys what is WAP?
wat is the difference betweem MSC & GMSC, & MSS & GCS?
what is EDAp? what is the functions of EDAP?
What is a circuit id?
what is sdh?
You would like to assign a meaningful name to your Catalyst switch. What command should you use?
sukumaranherakle 01-July-2007 04:00:18 PM
Comments


www.shrubbery.net/rancid/FAQ
Posted by crouse


en.kioskea.net/forum/affich-36712-switch-command-help
Posted by crouse


hostname
Posted by ctcaabay


exactly
we give on global configuration mode
)#hostname
Posted by mrleo99098


hostname
Posted by waqqas1


Example:
config(mode)#hostname
Posted by anilraj25


The command is "hostname".
Posted by manuel
Print Email    Post a answer Report Abuse   Previous Q & A   Next Q & A
Q&A Rating

Q&A Rating
Rate This Question and Answer

Related Questions
You are give IP address and subnet mask. What is the network address in binary?
 		Can any one explain the Fax service call flow.IF possible pls send the link if there is any document regarding this call flow
Explain Spreading in CDMA?

Search questions via popularity
Top viewed questions  Top emailed questions  Most printed questions  Most saved questions
 
Help - TERMS - PRIVACY - CONTACT US - ABOUT US - RFP XML FEED XML - CURRENCY CONVERTER - TOP
Copyright © Telecom Training, All Rights Reserved