4 Knowledge Base

 

 TelecomTrainning.net > Knowledge Base
 Viewing KB Article
Good Morning, - Please register or - log-in to your account.
Search
Search   Saved Questions   Ask a question
Keywords 
 
Available categories
LTE
100 of Questions in LTE
CCNA Certification
CCNA Sample Q & A (1000 + Q &A)
(Network +) Certification
(Network +) Sample Q & A (1000 + Q &A)
Networking
General/Interview Q& A on Networking
Home Networking
General/Interview Q& A on Networking
VOIP, SIP & Asterisk
Q & A on VOIP,Ethereal, SIP & Asterisk
Telecom Test Equipments
Q & A on Telecom Test Equipment
PSTN / Wireline
General / Interview Q & A on PSTN / Wireline
LTE, Wireless, 3G ,Diameter and HSS
General/Interview Q & A on LTE, Wireless, 3G ,Diameter and HSS
Telecom General
Any Q & A in Telecom in General

Top Questions
Friends, Describe Secure storage and distribution of A-Keys?
what is the difference between E1 signal & Ethernet signal ?
How do I monitor SS7 Traffic in spectra2?
Can you tell me about PBGT?
Explain me the difference between a repeater, bridge and router? Relate this to the OSI model.
What is the difference between BRI & PRI ?
Guys what is the purpose of Umbrella Cell Approach in GSM ?
how can we explain media gateway in MSc?
What is the difference between Electrical-tilt and Mechanical-tilt of an antenna?
What is GGSN?
What is BSC?
What is demarc point?
Can any one explain me how sms flow will work using ss7 network ?( from physical layer to application layer)
why cellphone towers are painted in red and white?
Explain SLTA and SLTM messages in MTP3?
Hi guys what is WAP?
wat is the difference betweem MSC & GMSC, & MSS & GCS?
what is EDAp? what is the functions of EDAP?
What is a circuit id?
what is sdh?

Which command will create a dynamic pool named Todd that will provide you with 30 global addresses?
michaelchristopher 24-May-2009 04:11:08 AM

Comments


I think ip nat pool Todd 171.16.10.65 171.16.10.94 net 255.255.255.224...
Posted by mylife


The command is: ip nat pool Todd 171.16.10.65 171.16.10.94 net 255.255.255.224...
Posted by HamidAliKhan


the command would be:

ip nat pool Todd 171.16.10.65 171.16.10.94 net 255.255.255.224...
Posted by sagitraz


The global addresses are

ip nat pool Todd 171.16.10.65 171.16.10.94 net 255.255.255.224...


Posted by rickwalker


www.hds.com/assets/pdf/hitachi-dynamic-provisioning-software-best-practices-guide-oracle.pdf
Posted by crouse

Q&A Rating

Q&A Rating
Rate This Question and Answer

Related Questions
What is Hard Hand off?
 
How to set up WPA security on Linksys Routers?
 
What is difference between command "Router(config-if)# no cdo run" and "Router(config-if)# no cdp enable"


Search questions via popularity
Top viewed questions  Top emailed questions  Most printed questions  Most saved questions
 
Copyright © Telecom Training, All Rights Reserved