4 Knowledge Base

 

 TelecomTrainning.net > Knowledge Base
 Viewing KB Article
Good Morning, - Please register or - log-in to your account.
Search
Search   Saved Questions   Ask a question
Keywords 
 
Available categories
LTE
100 of Questions in LTE
CCNA Certification
CCNA Sample Q & A (1000 + Q &A)
(Network +) Certification
(Network +) Sample Q & A (1000 + Q &A)
Networking
General/Interview Q& A on Networking
Home Networking
General/Interview Q& A on Networking
VOIP, SIP & Asterisk
Q & A on VOIP,Ethereal, SIP & Asterisk
Telecom Test Equipments
Q & A on Telecom Test Equipment
PSTN / Wireline
General / Interview Q & A on PSTN / Wireline
LTE, Wireless, 3G ,Diameter and HSS
General/Interview Q & A on LTE, Wireless, 3G ,Diameter and HSS
Telecom General
Any Q & A in Telecom in General

Top Questions
Friends, Describe Secure storage and distribution of A-Keys?
what is the difference between E1 signal & Ethernet signal ?
How do I monitor SS7 Traffic in spectra2?
Can you tell me about PBGT?
Explain me the difference between a repeater, bridge and router? Relate this to the OSI model.
What is the difference between BRI & PRI ?
Guys what is the purpose of Umbrella Cell Approach in GSM ?
how can we explain media gateway in MSc?
What is GGSN?
What is the difference between Electrical-tilt and Mechanical-tilt of an antenna?
What is BSC?
What is demarc point?
Can any one explain me how sms flow will work using ss7 network ?( from physical layer to application layer)
why cellphone towers are painted in red and white?
Explain SLTA and SLTM messages in MTP3?
Hi guys what is WAP?
wat is the difference betweem MSC & GMSC, & MSS & GCS?
what is EDAp? what is the functions of EDAP?
What is a circuit id?
what is sdh?

In Astreix for Analog connection application what are minimum hardware and drivers required?
adalson007 01-September-2008 01:49:24 PM

Comments


www.voip-info.org/wiki/view/Asterisk+hardware
Posted by crouse


www.voiplink.com/IP_PBX_Asterisk_Hardware_s/64.htm
Posted by crouse


FXS and FXO cards with Zapata Driver.
Posted by jackson


The existing phone service in many homes is analog Plain Old Telephone Service POTS for incoming lines from the phone company, also known as the Public Switched Telephone Network connected to regular analog phones. (Note: In the US ISDN, digital phone lines, never really took off the way in did in some parts of europe and Asia.) This page covers analog phones and phone lines only, in particularly the low end devices that are most appropriate for home use.

Asterisk can be used in all digital configurations using Voice over IP VoIP connections to software phones running on PC and to phone service providers that you can connect to over the internet. There are a lot of tutorials explaining how to do that. Those can be quite helpful for learning and getting started. However, once you want to start using Asterisk "for real", you'll probably want to integrate asterisk with your existing home phones and phone lines. I found a lot of the information was scattered in different places, so this page is an attempt to help people get started and help make an informed decision on what hardware to get.

While there is an ever growing set of choices for digitial VoIP phones, there is a much larger selection of plain analog phones available practically everywhere at very low price points. In terms of the economies of scale, look at how much smaller the choices are for 2 line phones. The handful of phones that are available with more than 2 lines that I've seen can cost about as much as your whole Asterisk installation. The majority of the available VoIP/SIP phones are hardwired. I believe the most desirable phones for home are cordless. Things are improving however, two of the largest consumer cordless phone producers, Uniden and VTech have announced cordless VoIP phones. Hybrid mobile phones that can do VoIP over WiFi when it's available and fall back to a cellular network (GSM, CDMA) look very promising, but it's still pretty early. I believe most high tech households that would be considering installing Asterisk probably already have a reasonable investment in the better cordless phones. If your home needs a lot of phones, implementing Asterisk could allow you to save quite a bit of money allowing you to buy fairly simple low end phones.

If you are reading this, you probably already know this but there are many reasons for introducing the Asterisk PBX into your existing home phone setup such as:

* Sophisticated Voice Mail system to replace that aging answering machine. This can provide a mail box per person, that can be deliver notification by e-mail. Web based access to your voice mail is also available.
* Interactive Voice Response IVR systems - You can present callers with a menu, which can be particularly useful if you have more people in the house than you have incoming phone lines. "Press 1 for Him, Press 2 for Her, Press 3 for Kid No. 1, Press 4 for Kid No. 2"...
* Control over which phones ring at what times.
* Intercom (Place in house calls)
* Routing incoming calls by Caller ID.
* Need more than 2 incoming lines (Phones that handle more than two lines are much more expensive than 1 or 2 line phones, and there isn't very much selection available.)
* Call Detail Reports (for attempting to gain some control over costs, and/or teenagers)
Posted by sagitraz

Q&A Rating

Q&A Rating
Rate This Question and Answer

Related Questions
How do you secure a wireless network?
Hi guys, what is the primary purpose of BSC?
Which WAN technology is the best choice if you have many remote offices that are in different states, you need always-on connectivity, and you don't have money to burn?
 


Search questions via popularity
Top viewed questions  Top emailed questions  Most printed questions  Most saved questions
 
Copyright © Telecom Training, All Rights Reserved