4 Knowledge Base

 

 TelecomTrainning.net > Knowledge Base
 Viewing KB Article
Good Evening, - Please register or - log-in to your account.
Search
Search   Saved Questions   Ask a question
Keywords 
 
Available categories
LTE
100 of Questions in LTE
CCNA Certification
CCNA Sample Q & A (1000 + Q &A)
(Network +) Certification
(Network +) Sample Q & A (1000 + Q &A)
Networking
General/Interview Q& A on Networking
Home Networking
General/Interview Q& A on Networking
VOIP, SIP & Asterisk
Q & A on VOIP,Ethereal, SIP & Asterisk
Telecom Test Equipments
Q & A on Telecom Test Equipment
PSTN / Wireline
General / Interview Q & A on PSTN / Wireline
LTE, Wireless, 3G ,Diameter and HSS
General/Interview Q & A on LTE, Wireless, 3G ,Diameter and HSS
Telecom General
Any Q & A in Telecom in General

Top Questions
Friends, Describe Secure storage and distribution of A-Keys?
what is the difference between E1 signal & Ethernet signal ?
How do I monitor SS7 Traffic in spectra2?
Can you tell me about PBGT?
Explain me the difference between a repeater, bridge and router? Relate this to the OSI model.
What is the difference between BRI & PRI ?
Guys what is the purpose of Umbrella Cell Approach in GSM ?
how can we explain media gateway in MSc?
What is GGSN?
What is the difference between Electrical-tilt and Mechanical-tilt of an antenna?
What is BSC?
What is demarc point?
Can any one explain me how sms flow will work using ss7 network ?( from physical layer to application layer)
why cellphone towers are painted in red and white?
Explain SLTA and SLTM messages in MTP3?
Hi guys what is WAP?
wat is the difference betweem MSC & GMSC, & MSS & GCS?
what is EDAp? what is the functions of EDAP?
What is a circuit id?
what is sdh?

How to Generate VOIP Traffic and view stats in INET
david 06-October-2007 01:14:31 PM

Comments


You may Generate VOIP Traffic and view stats in INET by following steps Open workspace -> create system configuration -> ADD a VOIP traffic model -> click the + sign -> click scripts -> click add tree to add a blank script-> create a new voip generator script -> build the test model -> click RUN-> click the + sign and add voip stats and view the stats
Posted by HamidAliKhan


Sgitraz is right, But there should some extra parameters define.
Posted by waqqas1


Please Perform Following steps:

1.)Create sys conf
2.)Add Voip traffic model
3.)Click Script and add one
4.)Create new voip generator script
5.)Create test model and click run
6.)Finally add voip stat and view it
Posted by sagitraz


Open workspace -> create system configuration -> ADD a VOIP traffic model -> click the + sign -> click scripts -> click add tree to add a blank script-> create a new voip generator script -> build the test model -> click RUN-> click the + sign and add voip stats and view the stats
Posted by shree

Q&A Rating

Q&A Rating
Rate This Question and Answer

Related Questions
How To assign a network number to an interface that supports a single network, perform the following task in interface configuration mode:
 
How to change sip ports from 5060 to 9099 in Asterisk?
Hi Friends, For low cost how to increase fiber bandwidth?


Search questions via popularity
Top viewed questions  Top emailed questions  Most printed questions  Most saved questions
 
Copyright © Telecom Training, All Rights Reserved