4 Knowledge Base

 

 TelecomTrainning.net > Knowledge Base
 Viewing KB Article
Good Evening, - Please register or - log-in to your account.
Search
Search   Saved Questions   Ask a question
Keywords 
 
Available categories
LTE
100 of Questions in LTE
CCNA Certification
CCNA Sample Q & A (1000 + Q &A)
(Network +) Certification
(Network +) Sample Q & A (1000 + Q &A)
Networking
General/Interview Q& A on Networking
Home Networking
General/Interview Q& A on Networking
VOIP, SIP & Asterisk
Q & A on VOIP,Ethereal, SIP & Asterisk
Telecom Test Equipments
Q & A on Telecom Test Equipment
PSTN / Wireline
General / Interview Q & A on PSTN / Wireline
LTE, Wireless, 3G ,Diameter and HSS
General/Interview Q & A on LTE, Wireless, 3G ,Diameter and HSS
Telecom General
Any Q & A in Telecom in General

Top Questions
Friends, Describe Secure storage and distribution of A-Keys?
what is the difference between E1 signal & Ethernet signal ?
How do I monitor SS7 Traffic in spectra2?
Can you tell me about PBGT?
Explain me the difference between a repeater, bridge and router? Relate this to the OSI model.
What is the difference between BRI & PRI ?
Guys what is the purpose of Umbrella Cell Approach in GSM ?
how can we explain media gateway in MSc?
What is GGSN?
What is the difference between Electrical-tilt and Mechanical-tilt of an antenna?
What is BSC?
What is demarc point?
Can any one explain me how sms flow will work using ss7 network ?( from physical layer to application layer)
why cellphone towers are painted in red and white?
Explain SLTA and SLTM messages in MTP3?
Hi guys what is WAP?
wat is the difference betweem MSC & GMSC, & MSS & GCS?
what is EDAp? what is the functions of EDAP?
What is a circuit id?
what is sdh?
guys what is I MAC address?
Camron 03-October-2007 05:29:41 PM
Comments


www.webopedia.com/TERM/M/MAC_address.html
Posted by saqlain231


Layer 2 address.
Posted by crouse


Layer 2 address.
Posted by waqqas1


A MAC address is an address that uniquely identifies a network device.
Posted by HamidAliKhan


An address that uniquely identifies a network device.
Posted by howard
Print Email    Post a answer Report Abuse   Previous Q & A   Next Q & A
Q&A Rating

Q&A Rating
Rate This Question and Answer

Related Questions
Friends what command should you use to have your router load the valid Cisco IOS from a TFTP server?
 		 What does the command routerA(config)#line cons 0 allow you to perform next?
Friends Tell me What keystroke terminates setup mode?
 

Search questions via popularity
Top viewed questions  Top emailed questions  Most printed questions  Most saved questions
 
Help - TERMS - PRIVACY - CONTACT US - ABOUT US - RFP XML FEED XML - CURRENCY CONVERTER - TOP
Copyright © Telecom Training, All Rights Reserved