4 Knowledge Base

 

 TelecomTrainning.net > Knowledge Base
 Viewing KB Article
Good Evening, - Please register or - log-in to your account.
Search
Search   Saved Questions   Ask a question
Keywords 
 
Available categories
LTE
100 of Questions in LTE
CCNA Certification
CCNA Sample Q & A (1000 + Q &A)
(Network +) Certification
(Network +) Sample Q & A (1000 + Q &A)
Networking
General/Interview Q& A on Networking
Home Networking
General/Interview Q& A on Networking
VOIP, SIP & Asterisk
Q & A on VOIP,Ethereal, SIP & Asterisk
Telecom Test Equipments
Q & A on Telecom Test Equipment
PSTN / Wireline
General / Interview Q & A on PSTN / Wireline
LTE, Wireless, 3G ,Diameter and HSS
General/Interview Q & A on LTE, Wireless, 3G ,Diameter and HSS
Telecom General
Any Q & A in Telecom in General

Top Questions
Friends, Describe Secure storage and distribution of A-Keys?
what is the difference between E1 signal & Ethernet signal ?
How do I monitor SS7 Traffic in spectra2?
Can you tell me about PBGT?
Explain me the difference between a repeater, bridge and router? Relate this to the OSI model.
What is the difference between BRI & PRI ?
Guys what is the purpose of Umbrella Cell Approach in GSM ?
how can we explain media gateway in MSc?
What is GGSN?
What is the difference between Electrical-tilt and Mechanical-tilt of an antenna?
What is BSC?
What is demarc point?
Can any one explain me how sms flow will work using ss7 network ?( from physical layer to application layer)
why cellphone towers are painted in red and white?
Explain SLTA and SLTM messages in MTP3?
Hi guys what is WAP?
wat is the difference betweem MSC & GMSC, & MSS & GCS?
what is EDAp? what is the functions of EDAP?
What is a circuit id?
what is sdh?

Guys explain me how to create a point code in Spectra2 Tester?
sean 29-December-2008 01:17:10 AM

Comments


in short point code could be created manually
or automatically by the system.
Posted by HamidAliKhan


1. Open a workspace.
2. Create a system configuration.
3. Click the Database tab -> Click Point Code -> Select a protocol -> Select a network indicator -> Enter the point code -> Enter a name for the point code.
Posted by craig


((it done automatically))
Posted by waqasahmad


there is no need to create it , it done automatically
Posted by Hash007


point code could be created manually
or automatically by the system.
Posted by waqqas1


Spectra2 tester can monitor, test, generate
(simulate up to 60,000 user agents), and
automate testing of VoIP and PSTN signaling and
media.So point code could be created manually
or automatically by the system.
Posted by sagitraz

Q&A Rating

Q&A Rating
Rate This Question and Answer

Related Questions
Hi guys how would i configure an access list to only allow traffic from network 141.75.0.0 to enter serial interface sO?
 
G711 is an example of PCM or ADPCM type of CODEC?
 
What is the maximum Segment length on a 1000Base-T cable network with CAT5 cabling?
 


Search questions via popularity
Top viewed questions  Top emailed questions  Most printed questions  Most saved questions
 
Copyright © Telecom Training, All Rights Reserved