4 Knowledge Base

 

 TelecomTrainning.net > Knowledge Base
 Viewing KB Article
Good Morning, - Please register or - log-in to your account.
Search
Search   Saved Questions   Ask a question
Keywords 
 
Available categories
LTE
100 of Questions in LTE
CCNA Certification
CCNA Sample Q & A (1000 + Q &A)
(Network +) Certification
(Network +) Sample Q & A (1000 + Q &A)
Networking
General/Interview Q& A on Networking
Home Networking
General/Interview Q& A on Networking
VOIP, SIP & Asterisk
Q & A on VOIP,Ethereal, SIP & Asterisk
Telecom Test Equipments
Q & A on Telecom Test Equipment
PSTN / Wireline
General / Interview Q & A on PSTN / Wireline
LTE, Wireless, 3G ,Diameter and HSS
General/Interview Q & A on LTE, Wireless, 3G ,Diameter and HSS
Telecom General
Any Q & A in Telecom in General

Top Questions
Friends, Describe Secure storage and distribution of A-Keys?
what is the difference between E1 signal & Ethernet signal ?
How do I monitor SS7 Traffic in spectra2?
Can you tell me about PBGT?
Explain me the difference between a repeater, bridge and router? Relate this to the OSI model.
What is the difference between BRI & PRI ?
Guys what is the purpose of Umbrella Cell Approach in GSM ?
how can we explain media gateway in MSc?
What is the difference between Electrical-tilt and Mechanical-tilt of an antenna?
What is GGSN?
What is BSC?
What is demarc point?
Can any one explain me how sms flow will work using ss7 network ?( from physical layer to application layer)
why cellphone towers are painted in red and white?
Explain SLTA and SLTM messages in MTP3?
Hi guys what is WAP?
wat is the difference betweem MSC & GMSC, & MSS & GCS?
what is EDAp? what is the functions of EDAP?
What is a circuit id?
what is sdh?

Explain Clipping?
jackson 16-September-2008 01:43:39 PM

Comments


Clipping is opposite or echo. If voice is repeated its called Echo. A call
B and voice path is established. When A says “Hello how are you" B can only
hear "lo hw ae ou"

Posted by alwin



Clipping is one form of distortion that occurs when an amplifier is overdriven, which happens when it attempts to increase voltage or current beyond its limits.

When an amplifier is asked to create a signal greater than its maximum capacity, it will amplify the signal only up to its maximum capacity, at which point the signal will be amplified no further. As the signal simply "cuts" or "clips" at the maximum capacity of the amplifier, the signal is said to be "clipped." The extra signal which is beyond the capability of the amplifier is simply cut off, resulting in a fixed signal. Note that this fixed signal suffers from other forms of distortion, such as total harmonic distortion.

Because the clipped waveform has more area underneath it than the smaller unclipped waveform, the amplifier produces more power in clipping. This extra power can damage any part of the loudspeaker, including the woofer or the tweeter.
Posted by sagitraz

Q&A Rating

Q&A Rating
Rate This Question and Answer

Related Questions
What should be the SIP response message for ISUP cause value 29 facility rejected?
 
Which is the meaning of C31 and C32?
 
Can u tell me What is Softphone?


Search questions via popularity
Top viewed questions  Top emailed questions  Most printed questions  Most saved questions
 
Copyright © Telecom Training, All Rights Reserved