4 Knowledge Base

 

 TelecomTrainning.net > Knowledge Base
 Viewing KB Article
Good Morning, - Please register or - log-in to your account.
Search
Search   Saved Questions   Ask a question
Keywords 
 
Available categories
LTE
100 of Questions in LTE
CCNA Certification
CCNA Sample Q & A (1000 + Q &A)
(Network +) Certification
(Network +) Sample Q & A (1000 + Q &A)
Networking
General/Interview Q& A on Networking
Home Networking
General/Interview Q& A on Networking
VOIP, SIP & Asterisk
Q & A on VOIP,Ethereal, SIP & Asterisk
Telecom Test Equipments
Q & A on Telecom Test Equipment
PSTN / Wireline
General / Interview Q & A on PSTN / Wireline
LTE, Wireless, 3G ,Diameter and HSS
General/Interview Q & A on LTE, Wireless, 3G ,Diameter and HSS
Telecom General
Any Q & A in Telecom in General

Top Questions
Friends, Describe Secure storage and distribution of A-Keys?
what is the difference between E1 signal & Ethernet signal ?
How do I monitor SS7 Traffic in spectra2?
Can you tell me about PBGT?
Explain me the difference between a repeater, bridge and router? Relate this to the OSI model.
What is the difference between BRI & PRI ?
Guys what is the purpose of Umbrella Cell Approach in GSM ?
how can we explain media gateway in MSc?
What is GGSN?
What is the difference between Electrical-tilt and Mechanical-tilt of an antenna?
What is BSC?
What is demarc point?
Can any one explain me how sms flow will work using ss7 network ?( from physical layer to application layer)
why cellphone towers are painted in red and white?
Explain SLTA and SLTM messages in MTP3?
Hi guys what is WAP?
wat is the difference betweem MSC & GMSC, & MSS & GCS?
what is EDAp? what is the functions of EDAP?
What is a circuit id?
what is sdh?

Can anyone Explain 99.99% reliability in TDM and IP Testing?
casey 17-December-2008 08:37:04 PM

Comments


www.cisco.com/warp/public/cc/so/neso/vvda/iptl/5nine_wp.pdf
Posted by crouse


Yes i think its impossible to achive 100% reliability
Posted by HamidAliKhan


Ok it is impossible, but it is concept in telecom that is use for calculations.
Posted by waqqas1


yep its impossible to achive 100% reliability but for some info see below links,it may provide you some help

http://www.huawei.com/publications/view.do?id=2819&cid=5122&pid=61
Posted by Hash007


The 99.99% reliability in TDM and IP Testing is almost impossible to achieve.Because there are so much losses that would effect its reliability.
Posted by sagitraz


I think that 99.999% is hard to do even in traditional TDM deployments. It requires a lot of discipline and planning in operations to do this. Many providers are deploying VOIP services over old IP networks that were not designed to give 99.999% availability. IP was always a secondary non-critical service by many consumers and was not considered a critical service by Telephone companies. The IP networks need to be able to provide 99.999% availability before any service riding on it will be able to.
Posted by elie

Q&A Rating

Q&A Rating
Rate This Question and Answer

Related Questions
Compare 4-wire and dial up modem?
What is access channel?
I want to verify the encapsulation type being used at Data Link layer for interface s0. Which command can you use?
 


Search questions via popularity
Top viewed questions  Top emailed questions  Most printed questions  Most saved questions
 
Copyright © Telecom Training, All Rights Reserved