4 Knowledge Base

 

 TelecomTrainning.net > Knowledge Base
 Viewing KB Article
Good Morning, - Please register or - log-in to your account.
Search
Search   Saved Questions   Ask a question
Keywords 
 
Available categories
LTE
100 of Questions in LTE
CCNA Certification
CCNA Sample Q & A (1000 + Q &A)
(Network +) Certification
(Network +) Sample Q & A (1000 + Q &A)
Networking
General/Interview Q& A on Networking
Home Networking
General/Interview Q& A on Networking
VOIP, SIP & Asterisk
Q & A on VOIP,Ethereal, SIP & Asterisk
Telecom Test Equipments
Q & A on Telecom Test Equipment
PSTN / Wireline
General / Interview Q & A on PSTN / Wireline
LTE, Wireless, 3G ,Diameter and HSS
General/Interview Q & A on LTE, Wireless, 3G ,Diameter and HSS
Telecom General
Any Q & A in Telecom in General

Top Questions
Friends, Describe Secure storage and distribution of A-Keys?
what is the difference between E1 signal & Ethernet signal ?
How do I monitor SS7 Traffic in spectra2?
Can you tell me about PBGT?
Explain me the difference between a repeater, bridge and router? Relate this to the OSI model.
What is the difference between BRI & PRI ?
Guys what is the purpose of Umbrella Cell Approach in GSM ?
how can we explain media gateway in MSc?
What is the difference between Electrical-tilt and Mechanical-tilt of an antenna?
What is GGSN?
What is BSC?
What is demarc point?
Can any one explain me how sms flow will work using ss7 network ?( from physical layer to application layer)
why cellphone towers are painted in red and white?
Explain SLTA and SLTM messages in MTP3?
Hi guys what is WAP?
wat is the difference betweem MSC & GMSC, & MSS & GCS?
what is EDAp? what is the functions of EDAP?
What is a circuit id?
what is sdh?

10Base-2 has a maximum transmission rate of how much Mbps?
maveric 01-December-2007 01:05:06 PM

Comments


The maximum transmission rate is 10 Mbps.
Posted by waqasahmad


One base station required 2Mbps band width for radiated in network but depends upon the trafic load . if dense Area some of TS slot is free nso proper utilization of bandwidth is base station is cascading fron other site;
But fully given the band with is required 2Mbps
10Mbps required for the 10 Base station
Posted by satpal


10 Mbps
Posted by kk

Q&A Rating

Q&A Rating
Rate This Question and Answer

Related Questions
I have two separe networks 172.16.0.0 and 122.16.1.0 ,they are connected by CAT5 cable. Give an example so host of one network can connect to other ?
 
Guys, can u Explain me in detail how to FTP a stable Version of Asterisk?
Guys please help me understand What is a VLAN? What is an ELAN? What is the difference?


Search questions via popularity
Top viewed questions  Top emailed questions  Most printed questions  Most saved questions
 
Copyright © Telecom Training, All Rights Reserved