|
In BGP when router don't find the route then moves on which BGP state? HamidAliKhan 12-November-2008 03:57:30 PMComments www.bgp4.as/books Posted by crouse digitaltut.com/bsci-bgp-questions Posted by crouse The Border Gateway Protocol (BGP) is the core routing protocol of the Internet. It maintains a table of IP networks or 'prefixes' which designate network reachability among autonomous systems (AS). It is described as a path vector protocol. BGP does not use traditional IGP metrics, but makes routing decisions based on path, network policies and/or rulesets. BGP was created to replace the EGP routing protocol to allow fully decentralized routing in order to allow the removal of the NSFNet Internet backbone network. This allowed the Internet to become a truly decentralized system. Since 1994, version four of the protocol has been in use on the Internet. All previous versions are now obsolete. The major enhancement in version 4 was support of Classless Inter-Domain Routing and use of route aggregation to decrease the size of routing tables. Since January 2006, version 4 is codified in RFC 4271, which went through well over 20 drafts based on the earlier RFC 1771 version 4. The RFC 4271 version corrected a number of errors, clarified ambiguities, and also brought the RFC much closer to industry practices. Most Internet users do not use BGP directly. However, since most Internet service providers must use BGP to establish routing between one another (especially if they are multihomed), it is one of the most important protocols of the Internet. Compare this with Signalling System 7 (SS7), which is the inter-provider core call setup protocol on the PSTN. Very large private IP networks use BGP internally, however. An example would be the joining of a number of large Open Shortest Path First (OSPF) networks where OSPF by itself would not scale to size. Another reason to use BGP is multihoming a network for better redundancy either to multiple access points of a single ISP (RFC 1998) or to multiple ISPs. Posted by waqasahmad In BGP if the router does not have a route to that destination from any non-BGP source, the withdrawn route will be removed from the main routing table and it moves to Idle state. Posted by sagitraz |
Posted: 15-November-2008 03:46:44 AM By: sagitraz In BGP if the router does not have a route to that destination from any non-BGP source, the withdrawn route will be removed from the main routing table and it moves to Idle state. | |
Posted: 03-March-2009 12:01:53 PM By: waqasahmad The Border Gateway Protocol (BGP) is the core routing protocol of the Internet. It maintains a table of IP networks or 'prefixes' which designate network reachability among autonomous systems (AS). It is described as a path vector protocol. BGP does not use traditional IGP metrics, but makes routing decisions based on path, network policies and/or rulesets. BGP was created to replace the EGP routing protocol to allow fully decentralized routing in order to allow the removal of the NSFNet Internet backbone network. This allowed the Internet to become a truly decentralized system. Since 1994, version four of the protocol has been in use on the Internet. All previous versions are now obsolete. The major enhancement in version 4 was support of Classless Inter-Domain Routing and use of route aggregation to decrease the size of routing tables. Since January 2006, version 4 is codified in RFC 4271, which went through well over 20 drafts based on the earlier RFC 1771 version 4. The RFC 4271 version corrected a number of errors, clarified ambiguities, and also brought the RFC much closer to industry practices. Most Internet users do not use BGP directly. However, since most Internet service providers must use BGP to establish routing between one another (especially if they are multihomed), it is one of the most important protocols of the Internet. Compare this with Signalling System 7 (SS7), which is the inter-provider core call setup protocol on the PSTN. Very large private IP networks use BGP internally, however. An example would be the joining of a number of large Open Shortest Path First (OSPF) networks where OSPF by itself would not scale to size. Another reason to use BGP is multihoming a network for better redundancy either to multiple access points of a single ISP (RFC 1998) or to multiple ISPs. | |
Posted: 08-September-2009 02:22:24 PM By: crouse digitaltut.com/bsci-bgp-questions | |
Posted: 08-September-2009 02:23:58 PM By: crouse www.bgp4.as/books |