|
What is the max transmission rate of Fast Ethernet? bretpark 01-December-2007 01:06:05 PMComments In computer networking, Fast Ethernet is a collective term for a number of Ethernet standards that carry traffic at the nominal rate of 100 Mbit/s, against the original Ethernet speed of 10 Mbit/s. Of the 100 megabit Ethernet standards 100baseTX (T="Twisted" Pair Copper) is by far the most common and is supported by the vast majority of Ethernet hardware currently produced. Full duplex fast Ethernet is sometimes referred to as "200 Mbit/s" though this is somewhat misleading as that level of improvement will only be achieved if traffic patterns are symmetrical. Fast Ethernet was introduced in 1995[1] and remained the fastest version of Ethernet for three years before being superseded by gigabit Ethernet.[2] A fast Ethernet adapter can be logically divided into a Media Access Controller (MAC) which deals with the higher level issues of medium availability and a Physical Layer Interface (PHY). The MAC may be linked to the PHY by a 4 bit 25 MHz synchronous parallel interface known as a Media Independent Interface (MII). Repeaters (hubs) are also allowed and connect to multiple PHYs for their different interfaces. The MII may (rarely) be an external connection but is usually a connection between ICs in a network adapter or even within a single IC. The specs are written based on the assumption that the interface between MAC and PHY will be a MII but they do not require it. The MII fixes the theoretical maximum data bit rate for all versions of fast Ethernet to 100 Mbit/s. The data signaling rate actually observed on real networks is less than the theoretical maximum, due to the necessary header and trailer (addressing and error-detection bits) on every frame, the occasional "lost frame" due to noise, and time waiting after each sent frame for other devices on the network to finish transmitting. Posted by waqasahmad 100 MPS Posted by Espinozakirk |
Posted: 04-December-2007 11:45:48 AM By: Espinozakirk 100 MPS | |
Posted: 03-March-2009 01:14:50 PM By: waqasahmad In computer networking, Fast Ethernet is a collective term for a number of Ethernet standards that carry traffic at the nominal rate of 100 Mbit/s, against the original Ethernet speed of 10 Mbit/s. Of the 100 megabit Ethernet standards 100baseTX (T="Twisted" Pair Copper) is by far the most common and is supported by the vast majority of Ethernet hardware currently produced. Full duplex fast Ethernet is sometimes referred to as "200 Mbit/s" though this is somewhat misleading as that level of improvement will only be achieved if traffic patterns are symmetrical. Fast Ethernet was introduced in 1995[1] and remained the fastest version of Ethernet for three years before being superseded by gigabit Ethernet.[2] A fast Ethernet adapter can be logically divided into a Media Access Controller (MAC) which deals with the higher level issues of medium availability and a Physical Layer Interface (PHY). The MAC may be linked to the PHY by a 4 bit 25 MHz synchronous parallel interface known as a Media Independent Interface (MII). Repeaters (hubs) are also allowed and connect to multiple PHYs for their different interfaces. The MII may (rarely) be an external connection but is usually a connection between ICs in a network adapter or even within a single IC. The specs are written based on the assumption that the interface between MAC and PHY will be a MII but they do not require it. The MII fixes the theoretical maximum data bit rate for all versions of fast Ethernet to 100 Mbit/s. The data signaling rate actually observed on real networks is less than the theoretical maximum, due to the necessary header and trailer (addressing and error-detection bits) on every frame, the occasional "lost frame" due to noise, and time waiting after each sent frame for other devices on the network to finish transmitting. |